Detailed core automatic assembling taping machine rubber covered requirements
HY-B08 core automatic taping machine for assembling transformer magnetic core and peripheral adhesive tape package, work flow: the skeleton material, on the magnetic core material, under the magnetic core material, assembly and package glue, blanking. Below by Hui more Xiaobian with everyone explain about core automatic assembling taping machine rubber covered requirements.
1, core assembly, can not have obvious dislocation:
2, different material core can not be assembled in the same products, plus material pad GAP material shall be the temperature of 130 DEG C, core composite surface must be absolutely clean, otherwise the impregnation can cause "L" value decreased;
3, the assembly before confirming the core has no obvious damage, deformation;
4, such as SPEC request, according to the requirements of operation, if no requirements will be GAP core is assembled on the early group of winding side (horizontal BOBBIN), the PIN side (vertical BOBBIN);
5, the core layer of 2-3 tape winding tape fixed, flat, dense, adhesive tape starting at PIN side (vertical), a primary side (horizontal), ended at PIN side (vertical), a primary side (horizontal) corner, belt width to physical appearance or less than the core width of 0.3-0.5mm is preferred;
The core of automatic assembling taping machine operation video address: http://www.cixinji.com/news/news26.htm
Automatic assembly machine core encapsulated physical map:
