Detailed core encapsulated automatic assembly machine - Transformer Production Notes
Hui Yue Technology core automatic assembly machine is the core assembly of plastic bag with plastic packets of work for electronic products, transformers, high frequency transformers, what with everyone Detailed look at the process of making high-frequency transformer matter the attention. (about the Magnetic core Assemble machine)
1, when the starting winding (START) and end (FINISH) out of line when BOBBIN same side, must be affixed to the front end of the back end of the line piece of tape across the
(CROSSOVER TAPE) for isolation.
2, out of line in using the recess BOBBIN of qualifying, in principle, to line a groove way to qualify, if you can use the same PIN multiple sets of the same groove or
Adjacent grooves qualifying, only the solder and sleeving To avoid short circuits.
3, wound neatly around the need uniform principle of full BOBBIN winding area, in addition to drawing surface around the law when there are special provisions, drawing prevail
4, when the transformer plus Teflon sleeve and has retrace lines, coupled with its access lines Teflon sleeve shall be flush with BOBBIN groove mouth (or at least up
2/3 high), and since BOBBIN groove outlet to prevent the sleeve is too long will cause tension wire snapped. However, if the wound is L PIN horizontal line, the casing should be flush with the edge BOBBIN (or at least 2 / 3 Long)
5, the transformer must be added # 44 (or MY2L) as the retaining wall tape, the tape must be close to the walls of their stalls on both sides of the model. In order to avoid obesity and the impact of the leakage inductance of the line is too high, it requires more than the acetate cloth 2TS not overlap More than 5mm tape width retaining wall transformer with the relevant safety requirements, VED ACT width 3.2mm package around the law on both sides and around the law to be applied TUBE: P end 6mm / 4.8mm / 4.4mm / 4mm; TOP end 3mm / 2.4. mm / 2.2mm / 2mm when not required TUBE. when winding copper wire can be on the upside the wall, if the sleeve, the sleeve must be inserted into the retaining wall than 3mm.
Reminder: These are our Dongguan Hui Yue Technology for transformer production needs Detailed notes, such as the need to use plastic bag core automatic assembly machines, please call our consultation! ! !