Detailed Hui more automatic plastic bag machine running slow vibration factor
Our HY-B06 automatic machine is encapsulated in the bag melter increased vibration plate material, without manual operation in the plastic bag process, greatly reduce labor, increase efficiency, and then run them in a normal plastic bag automatic machine vibration disk will run slower factors, what does? Hui Xiao Bian by the following Detailed look with you.
1, spring break (about the Magnetic core Assemble machine)
2, the bottom is too thin
3, the installation table defective, missing hardness. If the device suspended in the table, will cause vibration is too weak, the thickness of the table should be at least 1-1 / 2 ", so as not to absorb vibration, cylindrical-type brace must be equipped with a triangular support piece.
4, the table is not level
Debris within 5 disc
6, a coil the air gap should be as small as possible
7, resulting in part from the fast-paced machine vibration plate slipping.
8, power fluctuations
9, the controller needs to re-adjust to fluctuations in the power grid.
10, part question: tolerance, bending, oil, etc.
11, the base plate and tighten the screws are not tight or the wrong place.
12, parts too
13, chassis improperly adjusted
14, material change, should try to re-tune the chassis trim disk
15, in the case of the use of a blower may have some problems that may exist: pressure instability, air pollution, water or oil, these contaminants will remain in the vibration plate surface, slow down the speed of the feed does not even go. Gas supply must be clean, dry, with a separate regulator, filter. Do not use a rigid tube feeding may reduce performance. Automatic bag melters should use flexible hoses.
Want Division I automatic bag melter further understanding, please call our advice!