The size of our vacuum impregnation machine: 900*700*1400mm+400*250*300mm; weight: 300kg+20kg. To discharge vacuum impregnation machine best position should be how to choose?
1, the equipment should be installed in a dry, ventilated, clean place.
2, the installation should be flat, the distance between the wall or other objects to keep at least 300 mm gap.
3, the working voltage of three-phase 380V power. Pay attention to the electrical wiring is correct. Check the motor to be connected. From the end of the pump for the clockwise direction. If the steering is inconsistent, then any on three lines in two. And pay attention to the motor is required to be grounded.
4, installation and use are paying attention to how much the vacuum pump oil, is appropriate in the oil window 3/2.
5, connecting pipe by pumping the container should be clean and dry, keep sealed pipe joint.
6, the pump outlet may be a small amount of exhaust gas from the exhaust pipe, can be used.
