Operation process of HY-R20 automatic casing machine
Our Dongguan Hui Yue technology automatic casing machine is used in conjunction with CNC winding machine, suitable for any manufacturer of CNC winding machine. In the purchase of our automatic wear casing machine at the same time, I will be the Secretary for the installation and commissioning, the test department after passing the test, but also to provide installation video to ensure quality.
A: the difference between working principle
By 1, the general pressure single block structure, in pressing the casing pressure block by air cylinder is directly above the pressure dynamic pressure to a fixed surface of casing pipe compaction block, the is pressing block single action structure, carrying tube is fixed on the plane can not be adjusted up and down.
2, free transfer machine adopts pressure block structure of double action, in pressing sleeve two pressing blocks by coherent structure through two cylinder horizontal compacting pressure block, the press block structure of double action, pipe surface is V type mobile surface pressure block under the pressing block)
Two: pipe mouth, mouth positioning of the line
1, the general machine uses the line mouth, the tube mouth can move up and down the structure. Line nozzle can not be done before and after positioning, in line with the installation of the mouth and the mouth to judge the distance between the top of the line nozzle to the pressure pipe knife. Reason: the is pressing block single action structure, loading plate is fixed on the plane can not be adjusted, to replace the line and pipe, diameter and diameter with diameter increased its center point relative to the carrier surface horizontal line form tolerance is also increasing, so we need to adjusting nozzle and pipe mouth with loading surface relative height, the machine can smoothly wear tube and threading. (not adjusted up and down, even if very close to the line and Guan Zhong also can not use)
2, avoid the machine adopts nozzle, nozzle fixed structure, and online mouth tube mouth and do the installation and positioning, to ensure installed after the completion of the nozzle and the nozzle to pipe cutting knife of the distance of a fixed distance (0.3mm 0.5mm mouth line mouth tube) tube. Reason: the is pressing block structure of double action can ensure replacement aircraft of the nozzle and the nozzle and V type loading surface of the relative height of the fixed value remains unchanged.
Three: the difference between the applicable scope of the mould
1, ordinary machine with a single V slot or U slot structure of fixed casing, general machine with 2 sets of die (large, small one). Do different diameter different die needs to be replaced, the estimate using the example is as follows: a small pressing block: 30L-24L big pressure block: 23L-20L do 28L tube and 20L tube replacement aircraft of the time, we need to replace the die. Because of the size of the 2 pressure between the tolerances, so after the replacement need to adjust the line mouth and mouth to solve the problem of tolerance.
2, the free adjustment machine adopts double V groove at the same time to intensify the fixed sleeve, its application scope is: small machine 30L-18L tube big machine 19L-14L diameter. There is no need to adjust the left and right to solve the tolerance problem.
Four: process difference
1, ordinary sleeving machine with manual lathe and CNC machining centers, and the decomposition of the parts processing, then through parts of its portfolio to. After the different machine assembly tolerance about 1.mm above, completely by adjusting after only can be assembled to, so in the use process machine for regulation of frequent, if encounter is not very proficient in this device, in the follow-up in the regulation of the machine can not be used.
2, free transfer machine tube machine all adopt CNC machining center processing, ensure products are assembled and tolerance of less than 0.05mm after projector and calibration correction machine precision can reach 0.02mm completely do not adjust the machine.
HY-R20 automatic casing machine operation process:
