How to adjust the automatic bag melter two spindle distance?
Dongguan Hui Yue Technology automatic bag melter is a two-axis package tape, tape the axial distance can be adjusted since the 25-85mm, then how to adjust the two-spindle automatic bag melter distance?
If you replace the wound product range, due to the size of the wound to change the product, you need to pitch positions of the two sliders on the rotating disk spindle indexing system between adjusted. First of all: turning the rotary dial so that the two sliders in a horizontal position, loosen the thumb screws to move two symmetrical adjustment slider so that the spindle center distance for the desired distance, and then tighten the screws slider. The second step: the need to adjust the position of the winding of the stepper motor, through the two elongated holes at the rear of the motor loosen the two fixing screws slide, the upper portion of the adjustment screw to adjust the machine through the peephole to the left observation, the motor connected to the shaft centerline section is adjusted to be consistent with the spindle centerline, then tighten the screws tighten motor skateboard. The third step: Rotate the rotating disk when observed by winding two spindle motor coupling section square grooves, location is the same, up and down the gap is consistent, if the deviation can be slightly adjusted the position of the slider again. As passed, the adjustment is completed.
Automatic bag melter physical map:
