Transformers automatic bag melter dislocation adjustment method
Transformers automatic bag melter for any vertical, horizontal transformer Jieke plastic bag, and the replacement of species is simple, rapid, suitable for a variety of jobs. If the transformer automatic bag melter misplaced, how to adjust the energy? (about the Magnetic core Assemble machine)
First Turn the machine off, open the case cover and manually restore individual components of the system to the correct position. Press and hold the Settings button, turn on the power switch until the LCD screen display above the words "positioning adjustment" and then release the setup button on the screen you can see there are three main parts of the state. Loosen the screws need to adjust the encoder shaft, looking at the screen, a hand rotary encoders, one hand holding the appropriate Allen wrench ready to tighten the screws encoder. Three parts to be adjusted separately, as follows: wound clockwise rotary encoder system must first adjust the encoder to allow on-screen "wound state" behind the display changes to "error" state, then clockwise rotary encoder to display just to "positive" state, with a wrench to tighten the screws encoder to adjust even completed, transposition system and cut and paste method of adjusting the winding system is basically the same system, but the rotary encoder counterclockwise direction becomes adjustment . After the adjustment is completed according to the start switch around once again, if there is deviation of the position you need to repeat the above steps to adjust.